The bed, as built
A day in the truck with a tape, working out how the bed over the lounge actually sits on the Happijac lift, and redrawing the whole build to match. The headroom above it matters most, so nothing got taller: the bed stays where it is, and the frame was worked around the lift's spools, motor and drive shaft instead.
How it goes together
- The Happijac's own black rails run along each side wall. Four aluminium struts lie flat across them, screwed up through the rails' holes. The deck sits on the struts.
- The head and foot boards stand on the rails, notched underneath so the struts pass through them. Everything is held with black corner braces and wood screws. No glue: it all comes apart.
- At the back, a 1x5 on the rails lines up with the rail ends, the clean edge you see from below. A 1 1/4 in slot sits between it and a second 1x5, for a phone, a Kindle or a mask. The head and foot boards close its ends.
- Only the head side is tall: 8 1/2 in, half an inch above the 6 in mattress, to carry the headboard. The foot, the back and the front are 1x5s, 4 1/2 in: they locate the mattress rather than wall it in, and the front stays low enough to slide over.
- Notches clear the lift at full height: the spools at both front corners, the drive shaft end at the driver back corner, and the motor at the passenger back corner.
- The headboard is hinged on the inside top edge of the head board. It folds down onto the mattress before the bed goes up, and back up once it is down.
- The underside is the office ceiling: four puck lights on a near-square grid, and a cable down the slot beside the driver-side back column to the control box in the upper cabinet.
Still to measure
- The drive shaft's underside at full up. It sets how tall anything in the slot can be, about 4 in for now.
- The bed's full travel, which also sets the length of the cable's drag chain.
- How deep the cable slot is beside the column.