TopeLeave about Dec 1

Systems / Outside / Air conditioning

Air conditioning

The undermount ICEBOX: condenser above the hitch, compressor under the floor.

5 TBD · 7 have it · also: Underbody boxesGrey water

Settle the compressor spot and the corner, then every part, most of them already in hand.

1 Measure 0 of 4 done

What the drawing still guesses. Type what you get; it goes to Claude with your other changes.

Evaporator corner

Which corner (taken as driver side, rear) and the height of the top of the unit.

Sets: ICEBOX evaporator and blower, Refrigerant hoses 1 to 4

Condenser ports

Looking at its end: is the small port lower than the large one where it sits now?

Sets: Dual-fan condenser, 26.4 x 14.7 x 4.94

Spare tire gap

From the rock guard down to the spare tire.

Sets: Dual-fan condenser, 26.4 x 14.7 x 4.94, Rock guard

Compressor spot

Clear space between the rails just ahead of the condenser: length and depth to the ground.

Sets: Compressor, in its stainless box, Refrigerant hoses 1 to 4

2 Settle

  1. Compressor Drawn underneath, between the rails ahead of the condenser: quiet inside, but hose 4 (evaporator back to it) runs about 8 ft, longer than the kit's 6. Or on the garage floor under the evaporator: kit hoses fit, but you hear it.
  2. Which corner "Top left of the garage": drawn on the driver side at the rear. Say if it is the passenger side.
  3. Through the back wall The lines come through the back wall or the floor in the corner? Drawn through the floor.
  4. Power About 55 A at 12 V: the cable size and breaker come with the battery location on the electrical plan.

3 Parts in build order

5 TBD7 have it

Outside

have ithave it

Dual-fan condenser, 26.4 x 14.7 x 4.94

Have it: Cruise N Comfort (owned) · qty 1

11.7 lb; almost flat, the small port lower than the large

Above the hitch frame in the rear overhang, between the frame rails.

have ithave it

Rock guard

Have it: Cruise N Comfort (owned) · qty 1

The mesh under it; the hitch frame takes the big hits.

have ithave it

Compressor, in its stainless box

Have it: Cruise N Comfort (owned) · qty 1

about 12 x 12 x 12, 29 lb; through-bolted with #8 bolts

Under the floor just ahead of the condenser, between the rails: the noise stays outside.

Inside

have ithave it

ICEBOX evaporator and blower

Have it: Cruise N Comfort (owned) · qty 1

about 13 x 11 3/4 x 10 1/2, 17.8 lb; mounted flat so its pan drains

High in the garage corner; the blower turns any way, 4 in ducts no longer than 4 ft each.

have ithave it

4 in vents and ducting

Have it: in the kit (2 vents) · qty 2

have ithave it

Control hub

Have it: Cruise N Comfort (owned) · qty 1

8.7 lb; 12 V cable to the compressor 5 or 7 ft

Inside, dry, in the garage floor's corner above the compressor.

TBDstock

Thermostat or manual control

Buy: Cruise N Comfort: DT-07 or manual control · qty 1

TBD until: which control came with it

Lines

TBDhave it

Receiver dryer

Have it: in the kit · qty 1

Upright, sight glass where you can see it, between the condenser and the evaporator: drawn by the compressor.

TBD until: find it in the kit

TBDstock

Refrigerant hoses 1 to 4

Buy: an automotive AC shop, or Cruise N Comfort's VES-HK kit · qty 4

#8 compressor to condenser, #6 condenser to dryer and dryer to evaporator, #10 evaporator back to the compressor, insulated.

TBD until: the run lengths once everything is placed: hose 4 runs about 8 ft here, the kit's is 6

have ithave it

Condensate drain, 3/8 ID

Have it: in the kit (12 ft) · qty 1

From the evaporator's pan down through the floor to outside.

TBDstock

Main power cable and breaker, about 55 A

Buy: Blue Sea circuit wizard to size it · qty 1

Not in the kit. 38 to 55 A at 12 V.

TBD until: the run length from the batteries, on the electrical plan

Commission

TBDstock

Evacuate and charge, by an AC shop

Buy: an automotive AC shop · qty 1

Vacuum, leak check and the refrigerant charge (R134a or R513a): a shop job with the gauges.

Tap a card to find it here. Tap a part to find its card.