TopeLeave about Dec 1

Systems / Outside / Awning

Awning

A Fiamma F45s under the passenger roof edge: legs to the wall, guylines.

3 TBD · 3 ready to order · also: DeckUnderbody boxes

Mounting angle, the awning, the legs to the wall. The drawing builds up as you scroll.

Build

Every step in order. Scroll and the drawing follows: it builds up to the step you are on and lights what that step adds.

Settle step 1

1

Check before ordering

  1. The door's open height and swing, the roof edge height, and the F45s legs' reach. The clearance over the open door comes from these.

Mount step 2

2

Mounting angle on the roof edge

  1. Aluminium angle the full 13 ft along the top of the passenger wall, as high as it goes, through-bolted into the 80/20 or the rack's rail.
  2. Backing plate on every bolt, Sikaflex in every hole, level end to end.

Caution This carries every load the awning sees. Into structure, never the fiberglass alone.

Awning steps 3 to 4

3

Hang the F45s

  1. The awning onto the angle per Fiamma's instructions, with a helper: about 60 lb.
4

Leg wall brackets and the pitch

  1. Leg wall brackets 8 in under the window line, through-bolted into the 80/20.
  2. Crank it out, clip the legs to the brackets, set the front rail at about 8 ft 3 off the ground: high enough that the open door passes under.
  3. Rafter in the middle if it has one.

Tip Mark the leg length that gives 8 ft 3 so it is set the same every time.

Wind step 5

5

Guylines

  1. Hook the two Tie Down S straps into the front rail ends, out and down to the stakes, cinch to the springs. Only when it blows.

Commission step 6

6

Test it

  1. Every test on the Test page.
Scroll the steps: the drawing follows. Tap a part to find its step.