Systems / Outside / Underbody boxes
Underbody boxes
Two Buyers boxes for the driver side, hung like the passenger ones.
Mark, lift, bolt. The drawing builds up as you scroll.
Build
Every step in order. Scroll and the drawing follows: it builds up to the step you are on and lights what that step adds.
Settle step 1
1
Read the passenger boxes
- Model numbers off both lids, the bolt size, the strips' thickness. Photograph one bolt from inside and from above if you can see it.
Hang the boxes steps 2 to 3
2
Driver front box
- Box against the crossmember bottoms, 3 1/2 behind the body front, its outside face flush with the body edge like the passenger one.
- Its two strips go under crossmembers A (6 to 10 back) and B (22 1/8 to 26 1/8). Mark three holes per strip through the box lip into each crossmember's lip.
- Rubber strip on the lip, the box up on a jack, strips inside, bolts up through strip, lip and crossmember, nylocks on top.
- Check the door drops fully and its stays hold it level: it is the grey valves' work table.
Caution Drill only the body crossmembers' lips, never the Ford frame rail.
3
Driver back box
- Same again, 136 1/2 to 166 1/2 back, flush with the back of the body and the body edge.
- Strips under the crossmember at its front edge (132 1/2 to 136 1/2) and the next one aft.
Tip The heater drops through the floor just ahead of this box: keep its exhaust clear of the door.
Commission step 4
4
Load and check
- Every test on the Test page before anything goes in the boxes.