Grey water
Kitchen and shower drains to the ground or a tank, through two fail-safe valves.
Prove it drains, fails to the ground, and stays clean.
Tests
Tap a test to see what it checks.
Kitchen to the ground
Fill the sink, pull the plug: water out through the screen, every joint dry with a paper towel.
Water test each drain
Fill the sink and pull the plug; run the shower 5 minutes. Every joint from below with a dry paper towel.
Pull the fuse
Set TANK, then pull the panel fuse: V1 must open and V2 shut by themselves. The test that matters most.
Fill the tank
Set TANK, fill through the sink: 85 percent alert, then at 95 it flips to Ground by itself.
Flush it through
Hose on F1, valves on Ground: clean water out of the outlet in seconds, at full flow.
Dump and drip
Fill the tank, open V3: it empties completely. Fill again, crack V4: a trickle, no puddle.
Washboard road
A rough road with the tank half full. Then the straps, the unions and the line straps.
A week later
Sniff at the sink, the shower drain, the box and the vent. Open the tank lid: dry.
Every month
Hose on F1 with the valves on Ground, hot water and an enzyme cleaner made for grey. Pull both HepvO membranes and rinse them. If the tank was used, rinse it through W9 with V3 open, then leave the lid off to dry.