TopeLeave about Dec 1

Systems / Living / The bed

The bed

The bed on the Happijac lift: frame, headboard, LEDs, pucks, the drag chain.

3 TBD · 20 ready to order · 2 ordered · 15 have it · also: Board shop drawingsBed manual (first build)Routing the channels

The frame, the slot, the headboard, every channel, the far end's volts, full travel, a road.

Tests

Tap a test to see what it checks.

Every channel

Warm, red, green, blue, the pucks white, the pucks red, fan 1 and fan 2 one at a time, full and dimmed: every run lights end to end, all four pucks change together, each fan spins on its own channel.

Fan

Both folded, lower the bed all the way: they touch nothing. Unfolded, they hold their angle on a bump. Channels 7 and 8 switch them on and off.

Far end

Everything full on: volts at the foot run's far end. Over 11.4, good; under, more +12 cores or a heavier pair.

Full travel

Raise and lower the bed slowly, three times, watching the chain: no rub, no snag, the U stays in the corner, clear of the column and the drive shaft.

Road

A rough road: no rattle from the chain, the junction box tight, the tape down, the folded headboard quiet.

Frame

Stand in the middle of the deck and bounce: nothing creaks, the diagonals still equal. Every brace screw snug.

Slot

Phone and Kindle in the slot, bed fully up: nothing touches the drive shaft, nothing falls through.

Headboard

Upright: lean back on it with a pillow, it stays. Lid supports locked, pull it toward you: it stays. Fold it: flat on the mattress; bed up, it clears the ceiling.

Tap a test to see what it checks.